If you are using your own modem and the settings need to be updated to connect to your Wi-Fi, see the settings below for Fibre, VDSL & ADSVL.
Fibre settings if you are using your own modem:
Interface |
Ethernet |
Encapsulation |
802.1Q |
Operating Mode |
MDI/MDIX |
VLAN Tagged |
Disabled |
VLAN Priority |
Disable |
Connection Auth Type |
PPPoE |
PPP Username |
pulseinternet (or anything) |
PPP Password |
password (or anything) |
Reconnect Mode |
Always on |
Address Mode |
Dynamic IP |
MTU |
Auto |
NAT |
Enabled |
IPv6 |
Enabled |
DNS Type |
Automatic |
VDSL settings if you are using your own modem:
Interface |
PTM |
Encapsulation |
802.1Q |
Operating Mode |
VDSL2 |
VLAN Tagged |
Enabled |
VLAN ID |
10 |
VLAN Priority |
Disable |
Connection Auth Type |
PPPoE |
PPP Username |
pulseinternet (Or anything) |
PPP Password |
password (Or anything) |
Reconnect Mode |
Always on |
Address Mode |
Dynamic IP |
MTU |
Auto |
Enable NAT |
Enabled |
IPv6 |
Enabled |
DNS Type |
Automatic |
ADSL settings if you are using your own modem:
Interface |
ATM |
Encapsulation |
VC MUX |
ATM QoS |
UBR Without PCR |
VPI |
0 |
VCI |
100 |
Operating Mode |
ADSL2+: Auto or G.992.5 Annex A |
VLAN Tagged |
Disabled |
Connection Auth Type |
PPPoA |
PPP Username |
pulseinternet (or anything) |
PPP Password |
password (or anything) |
Reconnect Mode |
Always on |
Address Mode |
Dynamic IP |
MTU |
Auto |
Enable NAT |
Enabled |
IPv6 |
Enabled |
DNS Type |
Automatic |